Run WRKLIB RJSCONVERT to confirm that you do not already have a copy of the RJSCONVERT library on your iSeries. If it returns no results, continue to step 3. If it does return results, RJSCONVERT has been installed on your iSeries in the past; ask your iSeries administrator whether to upgrade or clear the library and reinstall.
Make sure that:
FTP is running on the iSeries LPAR where you are installing RJSCONVERT.
Your account has the required system credentials. Note: If your account does not have the required system credentials, use QSECOFR or another account with *ALLOBJ special authority.
On the FTP server, make sure that NAMEFMT is set to 1, not 0. Note: NAMEFMT is set to 1 on most FTP servers.
If you are using FTP exit programs, create an exception or temporarily disable them during this installation.
Make sure that your RJSCONVERT license matches the iSeries serial, model, and LPAR numbers. If you do not have a license or do not know if your license matches, view our licensing help or contact RJS Technical Support.
Run CRTSAVF FILE(QGPL/RJSCONVERT) to create a temporary file on the iSeries to upload RJSCONVERT.LIB to.
Log in to the iSeries LPAR you are installing RJSCONVERT on from a PC by following the steps below:
Bring up a command line:
On older versions of Windows, click Start > Run, type cmd, and click OK.
On newer versions of Windows, click Start, type cmd, and press Enter. A Windows Console window opens.
Type ftp 126.96.36.199, where 188.8.131.52 is the IP address of the iSeries LPAR you are installing RJSCONVERT on.
Type the user name and password of the account you chose in Before You Install 3.2. Note: If you cannot log in, most likely either your account has a security restriction on the iSeries or you are using FTP exit programs. In both cases, contact your iSeries administrator to rectify.