This procedure is for saving the product libraries to preserve the embedded configuration.

Powertech Exit Point Manager (EPM) 7 is tied to Central Administration. Any save of the EPM 7 library requires including the Central Administration library. The two product libraries must always be handled together.

If the product Identity Manager (formerly Power Admin) is also installed do not use this document and contact Powertech Support for additional instructions. It is also tied to the Central Administration product so must be considered at the same time.

This procedure is only for saving the product libraries and the configuration within. If a move is intended, please contact support for separate instructions.

  1. End the Network Security and Central Administration monitor jobs with the following commands.

    Note: It is not required but without ending these jobs, the following library saves can take additional time to complete. There may be locks created by the jobs which may cause the save to timeout.

    PTNSLIB07/LENDCAPSUM (if job PTWRKMGT/ SUMCAPTRAN is running)

    PTNSLIB07/PNSENDMON

    PTNSLIB07/PNSENDDASH (if job PTWRKMGT/PTNSGMSTR is running)

    PTPLLIB/PPLENDMON

  2. Save the libraries PTNSLIB07 (Exit Point Manager) and PTPLLIB (Central Administration)

    Suggested commands to save the libraries:

    SAVLIB LIB(PTNSLIB07) DEV(*SAVF) SAVF(QGPL/PTNSLIB7) SAVACT(*LIB) PVTAUT(*YES)

    SAVLIB LIB(PTPLLIB) DEV(*SAVF) SAVF(QGPL/PTPLLIB7) SAVACT(*LIB) PVTAUT(*YES)  

  3. When the saves are complete use the following commands:

    PTNSLIB07/LSTRCAPSUM (optional)

    PTNSLIB07/PNSSTRDASH (optional)

    PTNSLIB07/PNSSTRMON

    PTPLLIB/PPLSTRMON


Still have questions? We can help. Submit a case to Technical Support.

Last Modified On: July 06, 2019