Run CRTSAVF FILE(QGPL/RJSCONVERT) to create a temporary file on the iSeries to upload RJSCONVERT.LIB to.
Back up your existing library
Option 1 Run the following command on an iSeries command line as a security officer. This works well, assuming there are not a lot of object locks on the RJSCONVERT library. RNMOBJ OBJ(QSYS/RJSCONVERT) OBJTYPE(*LIB) NEWOBJ(RJSCNVBAK)
Option 2 Run the following command on an iSeries command line as a security officer. This works well, even if there are locks on the RJSCONVERT library; these locks will be forcefully removed when the library is cleared. CPYLIB FROMLIB(RJSCONVERT) TOLIB(RJSCNVBAK)
Install the new library version
Log in to the iSeries LPAR you are installing RJSCONVERT on from a PC by following the steps below:
Bring up a command line:
On older versions of Windows, click Start > Run, type cmd, and click OK.
On newer versions of Windows, click Start, type cmd, and press Enter. A Windows Console window opens.
Type ftp 184.108.40.206, where 220.127.116.11 is the IP address of the iSeries LPAR you are installing RJSCONVERT on.
Type the user name and password of the account you chose in Before You Install 3.2. Note: If you cannot log in, most likely either your account has a security restriction on the iSeries or you are using FTP exit programs. In both cases, contact your iSeries administrator to rectify.