FTP is running on the iSeries LPAR where you are installing RJSPOP3.
Your account has the required system credentials. Note: If your account does not have the required system credentials, use QSECOFR or another account with *ALLOBJ special authority.
On the FTP server, make sure that NAMEFMT is set to 1, not 0. Note: NAMEFMT is set to 1 on most FTP servers.
If you are using FTP exit programs, create an exception or temporarily disable them during this installation.
No additional license is required when performing an upgrade, assuming the serial, model, and LPAR numbers are the same. If you are upgrading your system as well, please apply for a temporary license.
On a Windows system on the same network as the iSeries, download the zipped RJSPOP3 save file.
Unzip RJSPOP3_1.17.ZIP to C:\.
Run CRTSAVF FILE(QGPL/RJSPOP3) to create a temporary file on the iSeries to upload RJSPOP3.LIB to.
Back up your existing library
Option 1 Run the following command on an iSeries command line as a security officer. This works well, assuming there are not a lot of object locks on the RJSPOP3 library. RNMOBJ OBJ(QSYS/RJSPOP3) OBJTYPE(*LIB) NEWOBJ(RJSPOPBAK)
Option 2 Run the following command on an iSeries command line as a security officer. This works well, even if there are locks on the RJSPOP3 library; these locks will be forcefully removed when the library is cleared. CPYLIB FROMLIB(RJSPOP3) TOLIB(RJSPOPBAK)
Install the new library version
Log in to the iSeries LPAR you are installing RJSPOP3 on:
Bring up a command line:
On older versions of Windows, click Start > Run, type cmd, and click OK.
On newer versions of Windows, click Start, type cmd, and press Enter. A Windows Console window opens.
Type ftp 22.214.171.124, where 126.96.36.199 is the IP address of the iSeries LPAR you are installing RJSPOP3 on.
Type the user name and password of the account you chose in Before You Install 3.2. Note: If you cannot log in, most likely either your account has a security restriction on the iSeries or you are using FTP exit programs. In both cases, contact your iSeries administrator to rectify.
CPYF FROMFILE(RJSPOPBAK/POPMSG) TOFILE(RJSPOP3/POPMSG) FROMMBR(*ALL) TOMBR(*FROMMBR) MBROPT(*REPLACE) CRTFILE(*NO) FMTOPT(*MAP) Note: You may only have POPMSG if you're using the POPGET command as this file gets automatically created by POPGET if it does not exist. You may simply continue if this file does not exist.
CPYF FROMFILE(RJSPOPBAK/POPMSG2) TOFILE(RJSPOP3/POPMSG2) FROMMBR(*ALL) TOMBR(*FROMMBR) MBROPT(*REPLACE) CRTFILE(*NO) FMTOPT(*MAP) Note: You may only have POPMSG2 if you're using the POPRECVJ command as this file gets automatically created by POPRECVJ if it does not exist. You may simply continue if this file does not exist.
WRKOBJPDM LIB(RJSPOPBAK) OBJTYPE(*DTAARA) Note: Place option 3 (Copy) next to each data area name, except for the data area named VERSION. Press enter to copy the data areas. Enter RJSPOP3 as the destination library. RMVLIBLE RJSPOP3