These pages contain articles relating to VISUAL Message Center (iSeries Modules).
Message ID: BDH0001 Message: VISUAL Message Center: the QHST monitor is not working properly and delaying message delivery.
An article explaining how to avoid the Crash Preventer Agent Is Not Active message.
How to change the Job Description to obtain more logging information.
The SECMONITOR job starts and ends immediately, if you take a look at the spool file, you'll see no errors. Cause . . . . . : Job 528611/QPGMR/SECMONITOR completed on 28/05/12 at 15:05:49 after it used 0,015 seconds processing unit time. The job had ending code 0. The job ended after 1 routing steps with a secondary ending code of 0. The job ending codes and their meanings are as follows: 0 - The job completed normally. [...] But although it doesn't show any errors nor failures, it ends immediately after it was started.
Into the Joblog of the BD_MONITOR you find messages with the text: "Duplicate record key in member BDHST02X" or "Duplicate key not allowed for member BDHST02X."
Product 5722999/5761999 *ALL not supported or installed
This article explains the solution when the DB2 Database file becomes corrupted.
When I try to get messages from an iSeries system in my SmartConsole I receive this error: "Error message received from the server, error code : 020Eh User XXXXX is not allowed to use SmartConsole at system YYYYYY."
How to create an iSeries scheduled job
These documents explain how to replicate iSeries products configuration.
A short guide on how to run SQLMONITOR without starting HSTMONITOR and USRMONITOR.
Starting the T4NICELINK subsystem by using the QSTRUP program
This document explains how it is possible to install Tango/04 products in an iSeries system without an FTP connection through another iSeries system with FTP connection.
Guide to using B_DETECTOR authorization lists.
This guide explains how to replicate VISUAL Message Center configuration and data from one iSeries to another iSeries.
SQLMONITOR does not start and the log shows the error ʺMAXIMUM OF 10 MONITORS ALREADY ACTIVEʺ
When you execute the command WRKACTJOB SBS(T4NICELINK) in your iSeries, you'll find that there are too many jobs called CEPJOBD.
How to analyze audit info when the server does not use SECMONITOR
A guide to troubleshooting an iSeries installation.